Unify OpenStage Phone Adapter Installation Manual download pdf (Page 13)

Installation

DeutschFrançaisNederlandsItalianoEspañolPortuguês English

Installation

Prerequisite: One operational OpenStage T system telephone.

The PhoneAdapter is installed between the phone and the connection cable.

This is a front view of the PhoneAdapter:

7. Connect the power supply unit to the power source and plug the other end into the

Q socket in the PhoneAdapter.

8. Place your OpenStage phone on a soft surface with the keyboard facing downwards.

9. Remove the cable from the socket on your phone and plug it into the "u

0 input

socket" on the PhoneAdapter.

10. Using the supplied cable, connect the socket on your OpenStage phone to the

0 Master output socket" on the PhoneAdapter.

Your phone is now operational again.

11. Push the "Analog/U

0 Slave" switch to the right if you want to connect a further U

phone or to the left if you want to attach an analog terminal.

12. Now connect the additional device as follows using the second cable supplied.

Connection of an additional U

0 system telephone:

Using the supplied cable, connect the socket on the telephone to the "U

0 Slave output

socket" on the PhoneAdapter

Connection of an analog terminal:

Connect the terminal to the "Analog output socket" on the PhoneAdapter. Use a cable sui-

table for the analog device (max. length of 10 meters). Only cables with a suitable western

jack (e. g. not TAE) can be used. You may be able to use the cable supplied with the Pho-

neAdapter, see ”Characteristics of the a/b interface” Æ Seite 14.

You must connect an OpenStage phone to the "U

0 Master" socket in order to be

able to operate devices on the "U

0 Slave" and "Analog" output sockets.

Power supply

unit

Up0

input socket

Up0 Master

output socket

Up0 Slave out-

put socket

Switch

analog/Up0 Slave

Analog out-

put socket

a/b u

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comments to this Manuals

No comments

Unify OpenStage Phone Adapter Installation Manual Page 13

Comments to this Manuals